EasyManua.ls Logo

BYD SEAL EV - Panoramic View System

BYD SEAL EV
206 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Panoramic View System*
When the power is on “OK”, tap
"Vehicle View" on the Infotainment home
page, press the Steering Wheel
button. The "Panoramic View" is enabled.
Landscape mode:
Tap the front, rear, right, and left
areas of the vehicle. A single view
of the vehicle's front, rear, right, and
left images is displayed in the image
section on the left.
In the single front and rear
views, double-tap the image section
to switch to a 180° perspective
displayed in full screen.
Tap the radar icon in the panoramic
view to enable the radar display, and
tap it again to disable. When the radar
display is enabled, an obstacle warning
is displayed as it is approached.
Portrait mode:
Tap any two of the front, rear, left
and right areas in the lower left
section. Single views of the two
selected locations are displayed in
the upper and lower right image
section.
Slowly tap the body image on the left
to switch between visible and invisible
body.
After the vehicle starts, the image
before last power-o󽗈 is displayed on
the invisible panoramic view interface.
Foreign bodies in the underbody
and surrounding blind areas may be
inconsistent with the actual ones. The
underbody image will be updated in
real time only after the vehicle has
moved, which must be driven beyond
its length for a complete update.
WARNING
The panoramic view system
has transparent panoramic view
function to view the image below
the vehicle. This function is only
used to assist in observation of
area below the vehicle during
parking/driving. Investigation of
foreign objects below the vehicle
and dangerous situations should
be carried out in any other
manner to ensure the safety of
personnel and the vehicle.
When the vehicle runs at a low
speed, the transparent panoramic
view function is a󽗈ected by speed
󽗊uctuation or multiple stops,
so there will be misalignment
between the images below the
vehicle and that outside the
vehicle.
The panoramic view system is
only used for assisting parking/
driving. Parking or driving the
vehicle only depending on this
system is unsafe, because there
are some dead zones both in
front of and behind the vehicle.
Therefore, the surroundings of the
vehicle should also be observed
by other means during parking/
driving to avoid accidents.
131
04
USING AND DRIVING

Table of Contents

Related product manuals