• Anchor supports (for the top tether)
are provided at the rear outboard seat.
Note
• Secure the top tether when
installing the CRS.
Installing Child Restraint
Systems
Precautions for installation
①Do not turn the anchorage lever trim
cover outward.
②Push the anchorage lever trim cover
inward in use.
③Press the upper part of anchorage lever
trim cover to reset after use.
Installing child restraint system:
1.
Open the anchorage lever trim cover
and install the child restraint system to
the seat.
REMINDER
• The anchorage lever is located on
the bevel at the rear end of the
seat cushion. It is visible when the
lower part of the child seat trim
cover is pressed. After the child
seat is removed, the upper part of
its cover needs to be pressed to
return the cover.
Warning
• When using the lower anchoring
device, make sure that no foreign
objects are around the anchoring
device and that the seat belt is not
stuck behind the child seat; make
sure that the CRS is securely xed.
Otherwise emergency parking or
an accident may result in serious
injury to the child or even death.
26
To Next Page
Loading...
