2. Open the anchor support cover.
3. Fasten the snap hook to the anchor
support and tighten the top strap to
ensure the strap is buckled securely.
①Top straps
②Anchor support
③Snap hook
REMINDER
• If the CRS is equipped with a top
tether, secure the tether to the
anchoring device.
CAUTION
• Push/Pull the child seat in
dierent directions to ensure it is
securely installed.
• If the driver seat obstructs the correct
installation of the CRS, install it on the
left rear seat.
• Do not use a rear-facing child restraint
system on a seat protected by front
airbag (active); otherwise, in the event
of an accident, the impact force
applied when the front passenger
airbag deploys rapidly will cause
severe injury or even fatal injury to a
child.
Always follow the instructions below
when using a child restraint on a rear
seat:
• Never use a rear-facing child
restraint on the front passenger seat
with an activated passenger airbag.
Activate the front passenger airbag
immediately when the rearward-facing
child restraint device is removed from
the passenger seat.
• If needed, adjust the front passenger
seat backwards so that there is no
contact between your child and vehicle
interior.
• If needed, the front passenger seat
back can be adjusted to securely
contact with the child restraint system.
• If needed, the front passenger
seatback can be adjusted so that it
has no secure contact with the child
restraint system.
• For child restraint systems with the
guide tting of belt attached to the
child seat headrest, ensure that the
guide tting is positioned forward or in
line with the seat belt upper anchorage
on the vehicle's B-pillar.
• Please make sure the seat moves
back completely and gets far from
the activated airbags when using the
forward-facing child restraint device.
27
01
SAFETY
To Next Page
Loading...
