BYD SEAL EV - Page 122

• This function is available at the 30~150
km/h (20~95 mph) speed range.
Usage
• To enable or disable ISLC, go
to Infotainment touchscreen
→
ADAS→ Driving Assist → TSR → ISLC
switch.
• When the TSR system is disabled,
the ISLC switch is grayed out and
unusable. ISLC is turned o󽗈 at this
time. The ISLC switch will be usable
after the TSR system is enabled again.
• ISLC can be activated provided that
ACC is active.
CAUTION
• The Intelligent SpeedLimit
Control (ISLC) system integrates
the Adaptive Cruise Control (ACC)
and Tra󽗋c Sign Recognition (TSR)
functions. Therefore, ACC and
TSR function precautions should
be followed during use (see the
previous chapter for details).
• The intelligent cruise control
system is a driving assistance
system, so the driver should keep
control of vehicle at all times.
•
ISLC performance depends on
weather conditions, lighting, and
tra󽗋c sign visibility. The system
may be unable to recognize signs
completely or clearly at night
or sunset, in rainy, foggy, hazy,
snowy or dusty environment,
when light is coming from the
back of the vehicle, or when there
is a sudden change in lighting.
• The ICC system integrates the
functions of ACC system an TSR.
Therefore, it is necessary to follow
relevant precautions for ACC and
TSR when you are using ICC.
WARNING
• ISLC only serves as a driving
assistance function, so the driver
must be fully responsible for
driving safety.
• In󽗊uence of weather, road
conditions, and other factors may
cause ISLC to fail or lead to late
alarms.
• Use ISLC based on your needs,
tra󽗋c, and road conditions.
Intelligent High Beam
(HMA)
The intelligent high beam (HMA) system
automatically activates or deactivates
the high beam based on current driving
conditions assessed by using sensors
of the multifunctional video controller,
when vehicle speed exceeds 35 km/h.
Status Description
• HMA standby: When the function is
enabled but not activated yet, a icon
is displayed on the instrument
cluster.
• HMA activated: With the function
enabled, when you set the light switch
to the auto lights position, the light
meets conditions, and vehicle speed
exceeds 35 km/h,
is displayed.
• HMA Failure: HMA has failed. A
icon
is displayed on the cluster at this time.
Usage
• To enable or disable HMA, go to
Infotainment system
, and tap ADAS
→ Driving Assist. The system defaults
to the previous settings when the
vehicle starts.
• With the function enabled and the light
switch is on “Auto", the light meets
conditions and vehicle speed is over
121
04
USING AND DRIVING