BYD SEAL EV - Page 127

When the vehicle is reversing at a speed
no more than 15 km/h, the RCTA system
detects the vehicles traveling in the blind
spot at the back through rear corner
mmWave radars. If the system judges that
a vehicle approaching from behind poses
a risk of collision, the side mirror warning
indicators 󽗊ash and an audible alarm is
given to alert the driver, reducing the
possibility of collision.
Front Cross Tra󽗋c Braking (RCTB)*
When the vehicle is reversing at a speed
no more than 9 km/h, the RCTB system
detects the vehicles traveling in the blind
spot at the back through rear corner
mmWave radars. If the system judges that
a vehicle approaching from behind poses
a risk of collision, emergency braking is
performed automatically.
Rear Collisions Warning (RCW)*
At vehicle speeds between 5-146 km/h,
if rear corner mmWave radar sensors
detect a risk of collision with a vehicle
approaching too quickly from behind on
the current lane, the hazard warning light
turns on to warn the driver in that vehicle
against a possible collision.
Door Open Warning (DOW)*
DOW is realized with rear corner radars
installed on both sides of the rear
bumper. When the vehicle is stationary
with doors unlocked, the system keeps
indicators on side mirrors solid on to
warn the driver if moving objects, such as
bicycles or automobiles, approach from
behind on an adjacent lane. If the driver
attempts to open the door at this time,
indicators on side mirrors and front- and
rear-row ambient lights begin to 󽗊ash.
Cruise Button Operation
• To enable or disable BSD, RCTA, RCTB,
RCW and DOW, go to Infotainment
touchscreen
→ ADAS → Active
Safety → Blind Spot Assist. The system
defaults to the previous settings when
the vehicle starts.
• When the blind spot assist system is
disabled, No relevant indicators are
displayed on the cluster.
• When the blind spot assist system is
standing by, if vehicle conditions, such
as speed or gear status, do not meet
the requirements of any function, a
gray indicator
is displayed on the
cluster and blind spot assist will not be
activated.
•
If the blind spot assist system
malfunctions, a yellow indicator icon
is displayed on the cluster.
• When the blind spot assist system
is active, A green indicator is
displayed on the cluster, meaning that
the function has been activated and
can trigger alarms at any time.
Precautions
• While the BSD system provides
assistance in monitoring blind spots
of rearview mirrors, it cannot replace
the driver's observation and judgment.
The driver must keep control of vehicle
at all times and drive properly and is
fully responsible for the vehicle.
• The BSD system may be unable to
provide adequate warning on target
vehicles approaching from behind at a
high speed.
• The driver should ensure the normal
operation of the BSD system, keeping
the BSD radar sensors in good
condition. For example, if they are
covered in dirt, snow or other
126