BYD SEAL EV - Page 137

vehicle easy to start, accelerate, and
climb under adverse driving conditions.
WARNING
• TCS may not work e󽗈ectively in
the following situations:
•When driving on slippery roads,
even if TCS is working properly,
it may not be able to control
the direction and meet power
requirements.
•Do not drive in conditions where
the vehicle may lose its stability
and power.
hill hold control (HHC)
After the brake pedal is released, HHC
maintains brake pressure for one second
to prevent backward sliding.
hydraulic brake assist (HBA)
When you press the brake pedal quickly,
HBA detects that the vehicle is in
emergency condition. It quickly increases
the brake pressure to the maximum so
that ABS can intervene more quickly and
shorten the braking distance e󽗈ectively.
Controller deceleration parking (CDP)*
for parking brake
Press P gear to start CDP when driving,
the vehicle will brake at a constant
retarded velocity until it stops (the
velocity is 0.4g when pressing the P gear,
the velocity goes to 0.8g when stepping
on the brake pedal at the same time). If
the driver release the P gear, CDP will stop
to work.
ESC Operation Instructions
Intelligent power braking system has the
following new functions compared with
the original ESC system:
• Brake assist mode
•The brake assist mode is used
to adjust the brake pedal feel.
The relation curve between the
brake pedal depth and the vehicle
deceleration varies across di󽗈erent
modes for the driver to choose their
preferred pedal feel.
•You can select "Comfort" or "Sport"
In Infotainment touchscreen
→
Vehicle settings → Intelligent Chassis
→ Active Suspension Mode.
• CST
•Comfort parking function: When the
vehicle decelerates to stop in a non-
emergency situation, the integrated
brake control system reduces the
stop-instant suspension pitch and
impact by controlling the brake
pressure of the four brakes, providing
a smooth stop feeling for the driver.
•
To enable or disable this function, go
to the Infotainment touchscreen
→ Vehicle Settings → Drive Comfort
→ Comfort Parking setting.
•
After the comfort parking function is
triggered, the braking distance may
increase by 2-5 cm, so increase the
distance from the vehicle or obstacle
ahead accordingly before stopping
your vehicle.
• Brake disc wiping
•Brake disc wiping function: When the
wiper switch is on or the rain sensor
detects rain, the integrated brake
control system applies a small brake
pressure to all four brakes so that
pads come into contact with discs
to remove the water 󽗉lm from the
discs. This shortens brake response
time and braking distance.
•As long as the system detects rain
or the wiper ON signal, the brake
discs are repeatedly wiped at certain
intervals to improve safety.
• ESC working
•If there is a risk of skidding or
backsliding when the vehicle starts
on a slope, or if either drive wheel is
136