BYD SEAL EV - Page 152

1 Air puri󽗉cation operation
2 PM2.5 detection button
3 Quick Puri󽗉cation Button
4 Anion button
PM2.5 detection button
Tap PM2.5 detection. When the button
lights up, the system detects PM2.5
concentration inside/outside in real time
and displays the real-time value on
the infotainment touchscreen. PM2.5
detection stops when the button turns
o󽗈.
Quick puri󽗉cation button
Tap this button to enable fast puri󽗉cation.
Tap it a second time to end fast
puri󽗉cation.
Anion button
•
Function: sterilization, air puri󽗉cation,
refreshing.
• Tap the "Anion" button on the A/C
or green air puri󽗉cation interface
to inactivate or activate the anion
function.
REMINDER
• The PM2.5 value detected by the
on-board air puri󽗉cation (PM2.5)
detector is the PM2.5 value in
the air near the vehicle carrying
the device in a short time, which
should be di󽗈erent from the
daily or real-time PM2.5 value
declared by national and relevant
government authorities.
• The frequency of PM2.5 detection
should be reduced in the
following environments:
•
Sandstorms and other extremely
harsh environments;
•Cold regions (with ambient
temperature below -20°C).
•
High humidity environments
(relative humidity >90%);
REMINDER
•Environments with a change
in temperature (prone to
condensation), such as driving
in from a cold environment
to a high-temperature indoor
environment or parking lot.
• Running maximum air 󽗊ow speed
in internal circulation mode can
quickly reduce the concentration
of 󽗉ne particles in the air inside
the vehicle.
• In order to reduce odors from
the A/C, if the A/C is already
turned on, the A/C blower may
keep running for a while after the
vehicle is powered o󽗈 and locked.
That is because the condensed
water on the surface of the
evaporator needs to be dried to
prevent mold fermentation. It is
normal for the A/C blower to start
running automatically when you
lock the vehicle. No need to worry
about it.
A/C Settings
① A/C Settings Interface
• Press this button to open A/C Settings.
• Tap this button again to hide the A/C
setting interface.
151
05
IN-VEHICLE DEVICES