BYD SEAL EV - Page 162

Item Interval
Chassis screws
Check for them every 12 months or 20,000 km and replace
damaged parts in a timely manner.
Brake pedal and EPB switch
Check them at 12 months or 20,000 km for the 󽗉rst time,
and every 24 months or 40,000 km afterwards, or every 12
months or 20,000 km in severe driving conditions.
Brake friction block and disc Check them every 12 months or 20,000 km.
Brake piping and hoses
Check them at 12 months or 20,000 km for the 󽗉rst time,
and every 24 months or 40,000 km afterwards, or every 12
months or 20,000 km in severe conditions
Guide pin of brake caliper
assembly
Check it every 24 months or 40,000 km.
Steering wheel and tie rod
Check it at 12 months or 20,000 km for the 󽗉rst time, and
every 24 months or 40,000 km afterwards, or every 12
months or 20,000 km in severe driving conditions.
Drive shaft boot
Check it at 12 months or 20,000 km for the 󽗉rst time, and
every 24 months or 40,000 km afterwards, or every 12
months or 20,000 km in severe driving conditions.
Ball pin and boot
Check them at 12 months or 20,000 km for the 󽗉rst time,
and every 24 months or 40,000 km afterwards, or every 12
months or 20,000 km in severe driving conditions.
Front and rear suspensions
Check it at 12 months or 20,000 km for the 󽗉rst time, and
every 24 months or 40,000 km afterwards, or every 12
months or 20,000 km in severe driving conditions.
Tire condition and in󽗊ation
pressure, incl. TPMS
Check for them every 12 months or 20,000 km and replace
damaged parts in a timely manner.
Front and rear wheel
alignment
Check it at 12 months or 20,000 km for the 󽗉rst time, and
every 24 months or 40,000 km afterwards, or every 12
months or 20,000 km in severe driving conditions.
Tire rotation (Check tire
pressure and condition at
least once a month)
Check the tire pressure and conditions at least once a
month and rotate tires every 10,000 km.
Door brake
Check it every 12 months or 20,000 km. Remove dust from
the tie rod with a wet soft cloth, apply 0.3-0.8 g grease to
the tie rod, riveted joints, and rotating shaft, and replace
damaged parts in a timely manner.
Wheel bearing clearance
Check for it at 12 months or 20,000 km for the 󽗉rst time,
and every 24 months or 40,000 km afterwards, or every 12
months or 20,000 km in severe driving conditions.
161
06
MAINTENANCE