4. Connect the other end of the red
positive (+) cable to the positive (+)
terminal of the charged low voltage
distribution box of the rescue vehicle.
5. Connect one end of the black negative
(-) cable to the negative (-) terminal of the
charged low voltage distribution box of
the rescue vehicle.
6. Connect the other end of the black
negative (-) cable to an applicable
tie point (clean, unpainted, solid and
grounded metal part) of the vehicle under
rescue.
7. Start the rescue vehicle and keep it
running for a while. Then try to start the
vehicle under rescue.
8. After the vehicle under rescue starts
normally, turn o the power of the rescue
vehicle, remove the jumper cables orderly
reverse to connection, and put them
away.
9. Install the hood trim panel, and close
the hood.
WARNING
• If the jumper cables are
connected or disconnected in the
wrong order, short circuit may
occur, resulting in vehicle damage
or personal injury.
• When starting the vehicle with
jumper cables, the clamps of the
jumper cables must not contact
each other or any conductive
parts other than the jumper
points, to avoid short circuits.
CAUTION
• If the vehicle being rescued
cannot be started after several
attempts, contact a BYD
authorized dealer or service
provider.
• The rated battery voltage of the
rescue vehicle should be 12V for
starting with jumper cables.
When the Vehicle Needs
Supporting
If the vehicle needs to be lifted or jacked,
the lifting arm or jack can only be placed
at the lifting points as shown in the gure.
• Pay attention to the followings when
lift or jack the vehicle to ensure safety:
•Park on solid, at ground.
190
To Next Page
Loading...
