BYD SEAL EV - Page 80

and protective trip due to high-power
charging, a󽗈ecting the normal use of
other equipment.
• Avoiding damage to the charging
equipment:
•Prevent the charging equipment
from su󽗈ering any mechanical
impact.
•Do not place the charging equipment
near heaters or other heat sources.
• Inserting the charging connector
before charging:
•Make sure that the charging
connector and charge port are
free of foreign objects, and that
the protective cap of the charging
connector terminal does not get
loose or deformed.
•
Hold the charging connector with
one hand, align the connector with
the charge port and push it in,
making sure that they are properly
connected.
• Removing the charging connector at
the end of charging:
•Stop charging 󽗉rst and make sure the
charge port is unlocked.
•Pull the connector with one hand.
•Do not force the charging connector
out while the charge port is locked,
otherwise the charge port may be
damaged.
• It is suggested to switch the ignition o󽗈
before charging.
• Precautions for charging the vehicle:
•Starting the vehicle to use A/C.
However, this is not recommended.
• The vehicle should be parked in a
ventilated area, and there should not
be any occupant inside when charging.
• The vehicle system automatically
stops charging when the high-voltage
battery is fully charged.
• To stop DC charging, turn
o󽗈
the charging machine before
disconnecting the charging connector.
In household AC charging, remove
the charging connector and then the
power plug.
• When charging is complete and the
charging connector is unplugged,
make sure that the charge port’s cap
and door are closed, otherwise water
or foreign materials may enter the port
and a󽗈ect its normal use.
•
During DC charging, the DC charging
power is relatively small during the
identi󽗉cation period to identify the
real capability of the charging pile
and allow the charging pile to exert
its maximum output capacity, thereby
bringing a better charging experience
to users. (Only motor booster DC
Charge)
• Before starting the vehicle, ensure
that the charging equipment is
disconnected. The locking mechanism
can damage the charging equipment
and the vehicle if the vehicle is
started with the charging connector
incorrectly inserted.
• When the temperature is low, it is
recommended to charge the vehicle in
heated space indoors.
• When the temperature is high, users
are advised to perform charging in a
cool and ventilated place.
• Battery temperatures that are too low
or too high can compromised vehicle
charging performance.
•When the battery is charged at
low temperatures, the temperature
control system can improve the
battery's low-temperature charging
capacity. It is normal that a
limitation in the charging pile output
capacity prolongs charging and
heating time, and increases heating
power consumption. It’s the normal
phenomenon.
79
04
USING AND DRIVING