BYD SEAL EV - Page 84

WARNING
front of the vehicle, or near the
tires.
• When using the equipment,
prevent it from getting rolled
over by the vehicle, dropped, or
trampled on.
• Never drop the equipment or
pull it directly by its cable.
Take caution when moving the
equipment.
• It is strictly prohibited to
modify, disassemble, or repair the
charging equipment and its ports.
• It is not recommended to use
any additional wire or adapter/
connector. If an additional
adapter is required, choose
a suitable cable diameter
(≥1.5 mm²) and the adapter/
connector parameters must meet
requirements.
•
Never use the charging equipment
if the household power strip cable
becomes soft, if the charging
connector cable is worn out, if the
insulation layer is cracked, or in
case of any other damage.
• Never use the equipment
when the charging connector,
power plug, or power strip is
disconnected or broken, or if there
is any sign of surface damage.
• To prevent failure of the charge
port door, do not open and close
it repeatedly. The recommended
time interval for opening and
closing the port door is at least
one second.
CAUTION
• The charging cable cannot be
placed in a spiral during charging,
as this will a󽗈ect heat dissipation.
CAUTION
• See the charging instructions for
speci󽗉c charging precautions.
REMINDER
• It is recommended to contact a
BYD authorized dealer or service
provider or local electrician to
select an appropriate power
supply according to requirements
of the charging equipment.
• Charging equipment grounding
instructions: The equipment must
be properly grounded. In the
event of failure or damage to the
equipment, the grounding cable
provides a minimum impedance
to circuit discharge and thereby
reducing the risk of electric shock.
•
The equipment comes with a
ground cable connecting its
ground point with that of the
power plug, which must match
a properly installed and well-
grounded power supply outlet.
2. Charging
• With the vehicle doors unlocked and
preferably powered o󽗈, press the
charge port door to open.
• Open the vehicle charge port cap,
and make sure that no obstacles exist
between the head of the charging
connector and the end of the charging
socket.
83
04
USING AND DRIVING