BYD SEAL EV - Page 99

recommended frequency is once a
week at least.
• To maintain long-term performance,
avoid continuously exposing the
vehicle to an environment with a
temperature above 60°C or below
-30°C for over 24 hours.
• If the tray dented inward or there
is scrari󽗉cation under the battery
package tray, it is suggested to check
at a BYD authorized dealer or service
provider.
• During operation of the vehicle,
avoid repeated rapid acceleration or
deceleration whenever possible.
•
During operation of the vehicle, avoid
operating the vehicle continuously
for a long time whenever possible;
otherwise, the temperature of power
battery will become excessively high,
a󽗈ecting the vehicle performance.
• If the cluster mulfunctions when
driving, it is recommended to contact
a BYD authorized dealer or service
provider for inspection as soon as
possible.
• When the temperature of power
battery is high, the vehicle
performance will be limited to some
extent. In this case, stop the vehicle
and wait until the temperature drops
before operating.
REMINDER
• If the meter drops to 0, the
battery must be recharged. If it
is not recharged within 7 days,
the battery may su󽗈er permanent
damage. Such damage is not
covered by BYD warranty terms.
• Driving range depends on a
number of factors, such as the
vehicle's available power, vehicle
age (current battery life), weather,
temperature, road conditions and
driving habits. Compared with
under normal temperatures, the
REMINDER
pure-electric driving range is
somewhat reduced and power
performance will also be a󽗈ected
in low or high temperature
environments.
Saving Energy and
Extending Vehicle Service
Life
•
Saving energy is simple and easy, and
it helps prolong the vehicle's service
life.
• Energy and repair cost saving tips:
1. Regenerative braking setting:
• This vehicle can regenerate energy and
the regenerating degree can be set
by Infotainment touchscreen
→
Vehicle setting → Energy management.
When regenerative braking is set to
high, energy recovery increases when
braking and coasting. Set this feature
according to your driving habits.
2. Maintaining constant speed:
• Constant speeds save energy.
Sudden acceleration, sharp turns
and emergency braking increase
consumption.
• Speeds should be kept constant
according to tra󽗋c conditions.
Additional energy is consumed each
time the accelerator is pushed.
• Acceleration should be gradual. Avoid
sudden acceleration or deceleration.
• Prevent emergency braking, and
subsequent brake wear, by keeping
an appropriate distance from vehicles
ahead, and paying attention to tra󽗋c
lights.
• Congested roads increase energy
consumption.
98