33
5 Test Functions
5.6 WiFi Status
Access only when a WLAN card is installed!
Function not available at A2+ !
The WiFi status function prints out a list the most important parameters of the accessible Wireless Access Points.
The printout occurs using the heat level and print speed specied in the Setup > Print param. menu.
Notice!
The printout occurs without taking the label gaps into consideration. This is why endless media are most
suitable for this purpose.
Insert printable medium (labels, endless paper) which extends across the entire printing width.
If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum width.
Press the menu button.
Select Test > WiFi status print menu.
Start printout with the button.
The printout can be cancelled with the cancel button.
WiFi status
Mach4/300 - 10/09/2007 -15:21:00
Firmware V3.11 (Aug 9 2007) - #111070553751
Channel Name/BSS ID WiFi signal strength Encryption
6 MyNet
●●●●●
WPA-PSK (TKIP)
00:11:6B:61:8D:C1 54,0 MBit/s
11 BT4233SA70
●○○○○
WEP
00:11:6B:61:AB:82 54,0 MBit/s
14 WiFi statusFig.
The parameters have the following meaning :
Column Meaning
Channel Channel; frequency range of the Access Point
Name/BSS ID Name of the wireless LAN
MAC address of the Access Points
WiFi signal
strength
Scale of the WiFi signal strength
Data transfer rate
Encryption Type of data encryption
18 Parameters of the WiFi statusTable
To Next Page
Loading...
Need help?
General
