43
6 Service Functions
6.7 Cleaning Interval
The Cleaning interval function is used for additional printhead maintenance control. The length of medium
which passes the printhead can be selected in increments of 100 m after which the printhead is to be cleaned.
Press the menu button.
Select Service > Cleaning interval menu.
Press the button.
Select the desired value with the | and } buttons or select Off to deactivate the Cleaning interval function.
Press the button.
If the set length of the medium (label strip, transfer ribbon) has passed the printhead and an error occurs in the ow
of the medium (e.g. label end, transfer ribbon end), the Clean printhead! message appears in the display.
The error message for the error which occurred is not displayed until the Clean printhead! message is
acknowledged. As long as no errors occur in the medium ow, no messages are displayed and the print job is
continued even if the cleaning interval has passed.
1.
2.
3.
4.
5.
To Next Page
Loading...
Need help?
General
