35
5 Test Functions
Example:
In the following two gures, the printout in ASCII Dump mode is contrasted with the "normal" printout of a label.
16 Example label printed normally (left) and in ASCII Dump Mode (right)Fig.
5.8 Test Grid
The Test grid function prints out the geometric pattern on a background grid. This allows you to assess the
evenness of the print quality.
The printout occurs using the heat level and print speed specied in the Setup > Print param. menu.
Notice!
The printout occurs without taking the label gaps into consideration. This is why endless media are most
suitable for this purpose.
Insert printable medium (labels, endless paper) which extends across the entire printing width.
If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum width.
Press the menu button.
Select Test > Test grid menu.
Start printout with the button.
The geometric pattern is printed every 5 seconds once the Test grid function is started. During the pauses
between the printouts the printer can be adjusted.
The printout of the test grid can be cancelled with the cancel button.
17 Example test gridFig.
To Next Page
Loading...
