Attention!
Label sensor can be damaged!
Do not use sharp or hard objects or solvents to clean the label sensor.
The label sensor can become dirtied with paper dust. This can adversely affect label detection.
1
2
3
4
Figure 23 Cleaning the label sensor
1. Remove labels and transfer ribbon from the printer.
2. Loosen screw (2).
3. Hold pressed the button (1) and slowly pull label sensor outward via the tab (3). Ensure that the label sensor
cable is not tensioned by this.
4. Clean label sensor the slots (4) with brush or cotton swab soaked in pure alcohol.
5. Push label sensor back via tab (3) and set it ( 4.1.3 on page 14).
6. Reload labels and transfer ribbon.
To Next Page
Loading...
