CAB SQUIX - Connecting Printer to Power and Network

9
2 Installation
2.4 Connecting the Device
The standard available interfaces and connectors are shown in Figure 4.
2.4.1 Connecting to the Power Supply
The printer is equipped with a wide area power unit. The device can be operated with a supply voltage of
230 V~/50 Hz or 115 V~/60 Hz without adjustment.
1. Check that the device is switched off.
2. Plug the power cable into the power connection socket (28).
3. Plug the power cable into a grounded socket.
2.4.2 Connecting to a Computer or Computer Network
!
Attention!
Inadequate or no grounding can cause malfunctions during operations.
Ensure that all computers and cables connected to the label printer are grounded.
 Connect the label printer to a computer or network by a suitable cable.
FordetailsofthecongurationoftheindividualinterfacesCongurationManual.
2.5 Switching on the Device
When all connections have been made:
 Switch the printer on at the power switch (27).
The printer performs a system test, and then shows the system status Ready in the display (10).