23
END OF INSTALLATION STAGE 5
PLEASE CHECK THAT YOU HAVE CORRECTLY:
Ref Page
1. Set power setting, set dipswitches for
commissioning, ensure wire link is fitted
between terminals 1 & 2 and 2 & C1 5.1 16
2. Set the opening and closing times for gates 5.2 17
3. Adjusted the control panel 5.3 18
4. If required, activated automatic closing
and safety photocells 5.4 19
5. Programmed the remote to the control
panel 5.5 20
6. Coded the remote controls 5.6 21
7. Fitted motor covers 5.7 22
NOW STAGE 3 IS FULLY COMPLETED YOU ARE READY TO BEGIN
STAGE 4 OF YOUR FAST AUTOMATION KIT INSTALLATION.
To Next Page
Loading...
