2
INSTALLATION INSTRUCTIONS
CONTENTS
1) Stage 1:- Civil & Mechanical Section Page
1.1 PRE-INSTALLATION CHECK 3
1.2 MOUNTING THE MOTOR BASE PLATE 4
2) Stage 2:- Wiring & Electrical
2.1 BASIC CABLE LAYOUT 6
3) Stage 3:- Installation Section
3.1 INSTALLING THE MOTORS 8
3.2 INSTALLING THE DRIVE ARMS 9
3.3 ADJUSTING THE OPEN & CLOSED CAMS 10
4) Stage 4:- Wiring the Motors
4.1 ELECTRICAL CONNECTIONS TO THE ZF1 BOARD WITH PAIR OF GATES 12
4.2 ELECTRICAL CONNECTIONS TO THE ZF1 BOARD WITH SINGLE\ GATE 13
4.3 ELECTRICAL CONNECTIONS 14
5) Stage 5:- Commissioning the control Panel
5.1 INITIAL WIRING & CONTROL PANEL SETUP 16
5.2 OPENING & CLOSING THE GATES 17
5.3 CONTROL PANEL ADJUSTMENTS 18
5.4 AUTOMATIC CLOSE & SAFETY PHOTOCELLS 19
5.5 PROGRAMMING THE REMOTE CONTROLS TO THE CONTROL PANEL 20
5.6 CODING THE ADDITIONAL REMOTE 21
5.7 FINAL ASSEMBLY 22
6) Technical Information
7.1 ELECTRICAL CONNECTIONS 24
7.2 FUNCTION SELECTIONS 25
7.3 TECHNICAL DESCRIPTION - ZF1 CONTROL PANEL 25
7.4 MOTHERBOARD 26
7.5 ADJUSTMENTS 26
7) Troubleshooting Guide 27
8) Contact Information
“Time marches on but Came automation equipment stands the test of time...”
To Next Page
Loading...
Need help?
General
