01/2012 © CAME cancelli automatici s.p.a. - The data and information in this manual may be changed at any time and without obligation on the part of Came Cancelli Automatici S.p.a. to notify said changes.
ENGLISH
- Correct the horizontal (closing) position, in the same way.
N.B.: procedure to carry out after making electrical connections to the control panel.
Close the inspection hatch and power up the system. Activate the arm to check whether it is parallel to the road surface when close and
at about 89° when open.
Warning!The inspection hatch must be closed for opening and closing of the barrier arm to be safe and functional.
- To adjust the vertical (opening) position of the barrier arm, close it, open the inspection hatch and turn the screw clockwise (to
increase the the barrier-arm travel, or, counterclockwise to decrease it. n.
Note: before stopping completely the barrier-arm goes through a
slowing down phase thanks to a cam that triggers the slow-down
microswich. the microswitch is set at maximum advance. If you
wish to delay the slowing-down pahse, loosen the screws of the
o micro-switch ledge screws p, and position them outwards, see
drawing.
Adjusting the limit switches
To Next Page
Loading...
Need help?
General
