p. 6 - Manual FA01332-EN - 04/2019 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Original instructions
Control board
1 - Buttons for programming
2 - Display
3 - USB stick connector
4 - Encoder connector
5 - Motor connector
A p.n. ferrite is applied to the cable ECQK922091
6 - Terminal board for barrier status
7 - Terminal block for connecting the warning LED strip
8 - Terminal board for connecting the electric lock
9 - Accessories fuse
10 - Control board fuse
11 - Motor fuse
12 - Terminal block for motor power supply
13 - Terminal board for power supply to the control board
14 - Terminal board for NC contact for open cover
15 - Terminal board for NC contact for boom drop away
16 - Terminal board for NC contact for gearmotor release
17 - Terminal block associated with the RSE_2 connector for CRP or CAME KEY
connection
18 - Terminal block associated with the RSE_1 connector for combined or
alternate connection
19 - Terminal board for connecting control and safety devices
20 - Terminal board for connecting the keypad selector
21 - Terminal board for connecting the transponder selector
22 - Terminal board for connecting the antenna
23 - Connector for the R700 or R800 decoding card
24 - Connector for plug-in radio frequency card (AF)
25 - RSE_1 connector for RSE card
26 - RSE_2 connector for RSE card
A B GND A B GND R G B
24
10
S1 GND
AB
11 E1 E6 TS 1 2 3 3P 4 5 7 2 CX CY CZ
0300
TAMPER
FCA CM1 FCC CM2
EB
MOTOR
BLOCK
ARM
EB+
2
25
24
22 21 20 19 16 151718 14 13 12
3 544
23
26
6
7
8
9
10
11
1
To Next Page
Loading...
