p. 13 - Manual FA01332-EN - 04/2019 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Original instructions
Boom set up
Before adjusting the boom, check the accessories you want to fit and the passage clearance width.
Simple boom means the boom complete with slot cover, cap and rubber profile.
Passage width clearance / Duty-cycle
intermittence
< 2.5 m / 80% < 2.5 m / 100% 2.5 < 2.75 m / 100% from 2.5 a 3.8 m /
100%
Simple boom A1 = 1 A1 = 2 A1 = 1 A1 = 2
Boom with LED STRIP A1 = 1 A1 = 2 A1 = 1 A1 = 2
Balancing springs NO NO
A1 = 1
A1 = 2
001G02807 fixed rest MUST be used for passage clearance widths exceeding 3 m.
With A1 = 1, fast profile, the boom opening time varies from 1.2 to 2.5 seconds.
With A1 = 2, slow profile, the boom opening time varies from 2.5 to 4 seconds.
Establishing the travel end points with mechanical limit-switches
Check that the boom is parallel to the road surface when it is in the closed position and at about 89° when it is in the open position.
Correct the boom's horizontal position
Release the gearmotor
Open the inspection hatch.
1 - Turn the mechanical stop until the desired position of the boom is achieved.
2 - Fasten the mechanical stop with a counter nut.
Lock the gearmotor
~1°
~89°
+
-
❶
❷
+
-
To Next Page
Loading...
