CAME GARD PT Brushless - Safety Devices Connection

p. 17 - Manual FA01332-EN - 04/2019 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Original instructions
Safety devices
Connect the safety devices to the CX, CY and/or CZ inputs.
During programming, configure the type of action that must be performed by the device connected to the input.
If contacts CX, CY and CZ are not used they must be deactivated during programming.
DELTA photocells
Standard connection
Multiple photocell pairs can be connected.
DELTA photocells
Connection with safety test
Multiple photocell pairs can be connected.
See function F5, safety devices test.
2
10
A
B
11 E1 E6 TS 1 2 3 3P 4 5 7 2 CX CY CZ
FA
FC
BLOCK
+
10
-
11 NO C NC
+
10
-
11
RX TX
2
10
A
B
11 E1 E6 TS 1 2 3 3P 4 5 7 2 CX CY CZ
FA
FC
BLOCK
+
10
-
11 NO C NC
+
10
-
11
RX TX
DIR / DELTA-S photocells
Standard connection
Multiple photocell pairs can be connected.
DIR / DELTA-S photocells
Connection with safety test
Multiple photocell pairs can be connected.
See function F5, safety devices test.
2
10
S1 GND AB
11 E1 E6 TS 1 2 3 3P 4 5 7 2 CX CY CZ
FA
FC STB
TAMP
E
BLOCK
+
-
+
10
-
2TXCNC TX 2
RX TX
2
10
S1 GND AB
11 E1 E6 TS 1 2 3 3P 4 5 7 2 CX CY CZ
FA
FC STB
TAMP
E
BLOCK
+
-
+
10
-
2TXCNC TX 2
RX TX