Keyword Information and Location
IPAddressEth
Specifies the IP address for the internet interface connected via the
peripheral port to devices such as the NL115 and NL120. If this value is
specified as "0.0.0.0" (the default), the datalogger will use DHCP to
configure the effective value for this setting as well as the Ethernet
Default Gateway and Ethernet Subnet Mask settings. This
setting is the equivalent to the IPAddressEth status table variable.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Ethernet | IP
Address
IPGateway
Specifies the IP address of the network gateway on the same subnet as
the Ethernet interface. If the value of the Ethernet IP Address setting is
set to "0.0.0.0" (the default), the datalogger will configure the effective
value of this setting using DHCP. This setting is the equivalent to the
IPGateway status table variable.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Ethernet |
Gateway
IPGatewayCSIO
These settings specify the IP addresses of the router on the subnet to
which the first or second CS I/O bridge internet interface is connected.
The datalogger will forward all non-local IP packets to this address when
it has no other route. If the CS I/O IP Address setting is set to a value of
"0.0.0.0", the datalogger will configure the effective value of this setting
using DHCP.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: CS I/O IP |
Gateway
9. Tips and troubleshooting 147
To Next Page
Loading...
