Campbell CR1000X - Device Configuration Utility Settings (Continued)

Keyword Information and Location
Neighbours
This setting specifies, for a given port, the explicit list of PakBus node
addresses that the datalogger will accept as neighbours. If the list is
empty (the default value) any node will be accepted as a neighbour.
This setting will not affect the acceptance of a neighbour if that
neighbor's address is greater than 3999.
l String data type
Where to find:
l
Settings Editor tab in Device Configuration Utility: Com Ports
Settings | Neighbours Allowed
NTPServer
This setting specifies an NTPServer to be queried (once per day) to
adjust the datalogger clock. This setting uses the UTC Offset setting. If
UTCOffset setting is not set, it is assumed to be 0.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Advanced |
NTPServer
PakBusAddress
This setting specifies the PakBus address for this device. Valid values are
in the range 1 to 4094. The value for this setting must be chosen such
that the address of the device will be unique in the scope of the
datalogger network. Duplication of PakBus addresses can lead to
failures and unpredictable behavior in the PakBus network.
When a device has an allowed neighbour list for a port, any device that
has an address greater than or equal to 4000 will be allowed to connect
to that device regardless of the allowed neighbour list.
l Numeric data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Datalogger |
PakBus Address
9. Tips and troubleshooting 150