Keyword Information and Location
pppDial
Specifies the dial string that would follow the ATD command (#777 for
the Redwing CDMA).
Alternatively, this value can specify a list of AT commands where each
command is separated by a semi-colon (;). When specified in this
fashion, the datalogger will transmit the string up to the semicolon,
transmit a carriage return to the modem, and wait for two seconds
before proceeding with the rest of the dial string (or up to the next
semicolon). If multiple semicolons are specified in succession, the
datalogger will add a delay of one second for each additional
semicolon.
If a value of PPP is specified for this setting, will configure the
datalogger to act as a PPP client without any modem dialing. Finally, an
empty string (the default) will configure the datalogger to listen for
incoming PPP connections also without any modem dialing.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: PPP | PPPDial
pppDialResponse
Specifies the response expected after dialing a modem before a PPP
connection can be established.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: PPP | PPP Dial
Response
9. Tips and troubleshooting 154
To Next Page
Loading...
