Canon Canovision8 E50E - Page 151

3-14 Timing Belt (L), RC Gear, Loading Lever, Timing Belt (S), Joint Gear
* Disassembling (Fig.II-21)
(1) Set unloading state
(2) In the same procedures in "3-3", dismount the capstan motor.
(3) In the same procedures in "3-13", detach the pinch sub arm.
(4) Remove the washer @. Then dismount the RC gear @ (with the timing belt
(L) © hooked) from the shaft @.
{5) Remove the washer ©. Then, detach the loading lever while pushing the
claw @ toward the direction ®.
(6) Turn the stopper © toward the direction © by 90°.
(7)
Detach
the
joint
gear
@
(with
the
timing
belt
(S)
hooked)
from
the
shaft
rc
®.
(8) Separate the timing belt (Ss) @ from the relay pully ©.
yom
*Note: When dismounting the gear @, do not touch the flange © part. (Fig.D)
* Reassembling (Fig.I1-21)
(1) Apply 1/2 drop of oil to the shaft @. (Fig.F)
(2) Hook the timing belt (Ss) @ to the joint geaz @; and then to the ‘gear @-of
relay pully ® (Fig.5).
(3) Attach the joint gear @ to the shaft ® with the timing belt (S) at-
tached.
(4) Turn the stopper toward the © direction until it comes to an end. oar
(5) Apply 1/2 drop of oil to the shaft @. (Fig.A)
(6) Insert the loading lever into the shaft @. Then, match the @ part with
the claw @ and insert the pin @ into the groove of drive gear (right) ®.
(7) Secure the washer @.
(8) Hook the timing belt (L) @ to the gear as indicated in the Fig.B, and to
the gear © of the relay pully ©. (Fig.=)
(9) Mount the RC gear @ to the shaft @ (with the timing belt (L) @ attached).
Then, mesh it with the RK gear @.
(10) Secure the washer @.
(11) Apply the grease to the position of loading lever as indicated in
Fig.c.
(12)In the same procedures "3-14" and "3-3", assemble the pinch sub amm and
the capstan motor.
—_
oc engpagge reste
@iming belt (Ss)
‘ / Oal ;
@timing
belt
(1)
Zee
@
washer
snarcl®
1
|.
A Loadin {Joint gear i
pane Oreres 2 Fig.A Fig.D -
@ Washer @r@rin Relay pully -
4 ie i e
= lio
@re gear ~G | iT Ose Reel ee
™~@ |--°So |_@stopper - : -
~ Ol Fig.B Fig.E
@Relay
pully
wl
(ars
@shaft
:
~
Ba, TE [E72 arop 04
eee A
Loading Shaft I
ear nt) SSE _£@sha
ig: ed
Fig.C Fig F tf
Fig.II-21