DC10 E, DC20 E
SERVICE MODE / ADJUSTMENT
30
Error Code Table for CCD image Correction
Error No Error Conditions Error No Error Conditions
01 LED intensity low 0B RGB difference error
02 LED AE time out 0C Not used
03 Lc3 dummy leak too large 0D Shading error (horizontal slope)
04 Lc3 dummy leak ch difference too large 0E RGB absolute value insufficient
05 Not used 0F RGB absolute value is too large
06 Lc4 residual err too large 10 Chroma error between 2channels is too large
07 Lc4 residual err ch difference too large 11
Noise level difference between 2channels is too large
08 Lc3/lc4 slope too large 12 time out
09 Gain correction ch difference too large 13 range over
0A Measure abort
To Next Page
Loading...
