Canon imagePRESS Lite C170 - Page 15

Canon imagePRESS Lite C170 Series Service Guide
imagePRESS Lite C170 Series Service Guide March 2022
Revision 11 Page 7
Table 4 – Hardware Accessories
Item Item Number
2
Stack Bypass Alignment Tray-D1 3243C001AA
Long Sheet Feeding and Catch Tray-B1
18
1228C001AA
Long Sheet Catch Tray XL-A1
19,
4166C001AA
Paper Deck Unit-E1
20
0162C002AA
POD Deck Lite-C1
20, 21
0163C016AA
Copy Tray-R2
22
,
5
0164C002AA
Tab Feeding Attachment-F1
23
8930B001AA
Envelope Feeder Attachment-F1 (additional for main unit cassettes)
24
8928B001AA
Envelope Feeder Attachment-G1 (for POD Deck Lite-C1) 8929B001AA
Utility Tray-B1 0165C001AA
Upright Control Panel-H1 3323C001AA
Printer Cover-H2
25
0097C002AA
USB Key Board (Cherry)
26
1266V426
Copy Card Reader Attachment-A4 3730B004AA
Copy Card Reader-F1
27
4784B001AA
Canon Card Set-A1 (1-30) 4781B001AA
Canon Card Set-A2 (31-100) 4781B002AA
Canon Card Set-A3 (101-200)
4781B003AA
Canon Card Set-A4 (201-300) 4781B004AA
Canon Card Set-A5 (301-500) 4781B005AA
Canon Card Set-A6 (501-1000) 4781B006AA
Braille Label Kit-F1 7518A004AA
ADF Access Handle-A1 1095B001AA
Copy Control Interface Kit-A1
28
3726B001AA
Convenience Stapler-A1 (White) 1348V957
Universal Keyboard Stand-A1 2212V477
Card Reader Assembly for Universal Keyboard Stand 2212V478
2 Item Numbers, eLAN Item Numbers and Part Numbers are subject to change without notice.
5 The Staple Finisher-W1 PRO, Booklet Finisher-W1 PRO, Staple Finisher-AC1, Booklet Finisher-
AC1, and Copy Tray-R2 cannot be installed at the same time.
18 Stack Bypass Alignment Tray-D1 must be ordered.
19 Includes a long sheet high capacity tray for Staple Finisher-W1 PRO and Booklet Finisher-W1 PRO. The tray can support up to
51.2 inch. Highly recommended when configuration includes POD Deck Lite XL-A1.
20 Paper Deck Unit-E1 and POD Deck Lite-C1 cannot be installed at the same time.
21 The POD Deck-C1 includes the Registration Plate-A1.
22 Buffer Pass Unit which comes standard with the imagePRESS Lite C165 is not required when Copy Tray-R2 is attached.
23 Additional Tab Feeding Attachment for cassettes 3 or 4. The device comes standard with one Tab Feeding Attachment-F1.
24 Additional Envelope Feeder Attachment for cassettes 3 or 4. The device comes standard with one Envelope Feeder
Attachment -F1.
25 Requires removing the standard Single Pass Duplexing ADF and Reader.
26 When installing USB Keyboard it is recommended to install the Utility Tray-B1 or Universal Keyboard Stand-A1
27 Requires the Copy Card Reader Attachment Kit-A4
28 Cannot be installed if Card Reader-F1 is installed.