Installation/Settings Problems
1053-07F
See Common Problems(P. 502) also.
Icons in the description
Problem with the wireless LAN connection
Problem with the wired LAN connection
Problem with the USB connection
The machine cannot be connected to a computer via a wireless LAN, a wired
LAN and a USB cable at the same time.
● All three connection types cannot be used at the same time. The following can be used at the same time: a
USB cable and a wired LAN, or a USB cable and a wireless LAN.
Remote UI is not displayed.
● Are <Use HTTP> and <Use Remote UI> set to <On>?
Disabling HTTP Communication (imageRUNNER 2204F / 2204N / 2004N)(P. 394)
Disabling Remote UI (imageRUNNER 2204F / 2204N / 2004N)(P. 395)
● If the machine is connected to a wired LAN, check that the cable is connected rmly and the IP address is set
correctly, and then start the Remote UI again.
For how to check, see "Getting Started" Manuals Included with the Machine(P. 596) or Viewing
Network Settings(P. 326) .
● If the machine is connected to a wireless LAN, check that the settings are specied correctly, and then start
the Remote UI again.
For how to check, see "Getting Started" Manuals Included with the Machine(P. 596) or
Connecting to a Wireless LAN(P. 304) .
A connection to a network cannot be established.
● The IP address may not be set correctly. Set the IP address again.
Setting IP Addresses(P. 319)
● When you connect the machine to a computer via wireless LAN, check whether the machine is properly
installed and ready to connect to the network.
When the machine cannot connect to the wireless LAN(P. 506)
You are unsure of the set IP address.
Viewing Network Settings(P. 326)
The connection method cannot be switched between a wired LAN and a
wireless LAN.
Troubleshooting
504
To Next Page
Loading...
Need help?
General
