Entering Sleep Mode
1053-015
The sleep mode function reduces the amount of power consumed by the machine by disabling power ow to the
control panel. If no operations will be performed on the machine for a while, such as during a lunch break, you can
save power simply by pressing on the control panel. You can also use the Auto Sleep Time setting to
automatically put the machine into sleep mode if it remains idle for a specied length of time.
NOTE
When in sleep mode
When the machine enters sleep mode, lights up yellow green.
Situations in which the machine does not enter sleep mode
● When the machine is in operation
● When the [Processing/Data] indicator is lit up or blinking
● When the machine is performing an operation such as adjustment or cleaning
● When a paper jam occurs
● When the receiver of an external telephone is off the hook
● When the menu screen is displayed
● When a job is waiting to be scanned to a computer
● When an error message is displayed on the screen (There are some exceptions. The machine sometimes
enters sleep mode when error messages are displayed.)
When You Want to Set the Auto Sleep Timer
The factory default settings for the amount of time that elapses before the machine enters auto sleep mode are
listed below. We recommend using the factory default settings to save the most power. If you want to change
the amount of time that elapses before the machine enters auto sleep mode, follow the procedure below.
● 10 minutes (setting range is 3 to 60 minutes)
<Menu>
<Timer Settings>
<Auto Sleep Time>
Set the amount of time that elapses before the
machine automatically enters sleep mode
<Apply>
Basic Operations
72
To Next Page
Loading...
Need help?
General
