Feeder
1053-084
Dust and graphite powder may adhere to the roller inside the feeder and cause smudges to appear on printouts. To
clean the feeder, perform the following procedure. This procedure is necessary only if the feeder (DADF-AT1) is
attached.
Cleaning the Feeder Manually
Clean the areas with a well-wrung-out cloth dampened with water. Then, wipe the area with a soft, dry cloth.
1
Turn OFF the machine, and unplug the power cord from the AC power outlet.
● When you turn OFF the machine, data that is waiting to be printed is deleted. Fax documents that were
received by using the Memory Reception function, faxes that are waiting to be sent, and reports that are
automatically printed after sending and receiving faxes are not deleted.
2
Open the feeder cover.
3
Wipe rollers inside the feeder.
● Clean the rollers with a well-wrung-out cloth dampened with water. Then, wipe the area with a soft, dry cloth.
4
Open the inner cover, holding it by its front tab.
Maintenance
533
To Next Page
Loading...
Need help?
General
