Canon iPF710 - Page 46

Chapter 1
1-35
[Interface Setup]
T-1-15
Setting Item Description, Instructions
[EOP Timer] Specify the timeout period for print jobs.
[EOP Timer] [TCP/IP] Specify the TCP/IP protocol settings. To apply your
changes, choose Store Setting .
[IP Mode] Choose whether the printer IP address is configured
automatically or a static IP address is entered
manually.
[Protocol] [DHCP] Specify the protocol used to configure the IP address
automatically.
[BOOTP]
[RARP]
[IP Setting] [IP Address] Specify the printer network information when using a
static IP address.
Enter the IP address assigned to the printer, as well as
the network subnet mask and default gateway.
[Subnet Mask]
[Default G/W]
[NetWare] [NetWare] Specify the NetWare protocol. To apply your
changes, choose Store Setting .
[Frame Type] Specify the frame type to use.
[Print Service] Choose the print service.
[AppleTalk] Specify whether to use the AppleTalk protocol. To
apply your changes, choose Store Setting .
[Ethernet Driver] [Auto Detect] Specify the communication method. To apply your
changes, choose Store Setting .
Choose On for automatic configuration of the LAN
communication protocol. Choose Off to use settings
values of Comm.Mode and Ethernet Type .
[Comm.Mode] Choose the LAN communication method.
[Ethernet Type] Choose the LAN transfer rate.
[Spanning Tree] Choose whether spanning-tree packets are supported
over the LAN.
[MAC Address] Displays the MAC address.
[Ext.Interface] When installing the expansion interface board,
choose whether the expansion interface board is used.
[Init. Settings]
A confirmation message is displayed if you
press the[ ] button. Choose [OK] to restore
the network settings to the default values.