Canon iPF710 - Error Code List; Error Table

Chapter 8
8-3
8.3 Error Table
8.3.1 Error Code List
0014-1956
The codes correspond to the numbers shown on the DISPLAY in the service mode.
T-8-3
Code* Description
03010000-200C Media leading edge not detected
03010000-200D The trailing edge of cut sheet cannot be detected
03010000-200E Too small media
03010000-200F Too large media
03010000-2016 Paper came off at paper feed.
03010000-2017 Media right edge not detected
03010000-2018 Media left edge not detected
03010000-2820 Head registration in proper adjustment
03010000-2821 LF adjustment error
03010000-2822 Eccentricity improper adjustment
03010000-2823 Printhead check error
03010000-2E1F Media is too small to print adjustment pattern
03010000-2E27 Media became misaligned during printing
03010000-2F33 Transparent media was loaded and cannot adjust
03016000-2010 Skewed media
03016000-2010 Skewed media
03030000-2E21 IEEE1394 error
03031000-2E0F Upper cover error
03031000-2E11 Printhead fixer cover error
03031000-2E12 Release lever error
03060000-2E14 Width indicated by received data does not match width of paper
03060A00-2E00 Roll media was loaded even though the received data indicated roll media.
03060A00-2E1B End of roll media
03061000-2E15 Media type indicated by data does not match
03130031-260E Gap detection error
03130031-260F Standard side seat error(not generated in the user mode.)
03130031-2618 VH voltage error
03130031-2F13 A/D converter outside trigger output stop
03130031-2F14 ASIC register writing error
03130031-2F16 Mist fan error
03130031-2F17 Platen fan error
03130031-2F1F Purge motor HP error
03130031-2F20 Purge motor error
03130031-2F22 Pump movement timeout
03130031-2F23 Pump cannot operate