LASER CLASS 730i/720i/710 Chapter 4: Maintenance and Service
4-64
#3 NUMERIC PARAM. (numeric parameter settings)
No. Function
Selection range Default setting
010 T0 Timer 0~9999 5500 (55 sec)
011 T1 Timer (Rx) 0~9999 3500 (35 sec)
013 Maximum time to receive 500~3000 1300 (13 sec)
one line of image data
028 Menu selection screen display 1~60 3 (3 sec)
time length
056 Count type select 1 101 101
057 Count type select 2 0~999 201
058 Count type select 3 0~999 0
059 Count type select 4 0~999 0
060 Count type select 5 0~999 0
061 Count type select 6 0~999 0
070 Number of text lines possible for 0~9999 300 (300 lines)
mail reception
[No.010]
The “wait time after transmission of a dialing signal ends until a significant signal is
detected in transmission” was set as T1 timer with parameter 10. However, ITU-T
recommends that it should be set as T0 timer, so parameter 10 has been renamed to T0
timer and the default time-out time has been changed from 35 to 55 seconds.
NOTE
The T1 timer for the transmitter (wait time after a CED, V.21 flag, or ANSam
significant signal is detected until the next significant signal is detected) is
fixed at 35 seconds.
[No.011]
Set the T1 timer for the receiver (wait time after DIS transmission starts until a significant
signal is received).
If frequent errors occur during reception because of line connection conditions, raise the
value of this parameter.
[No.013]
Set the maximum time to receive one line of image data when image data is received.
If the other party is a computer fax and the time to receive one line of image data is long,
raise the value of this parameter to increase the maximum reception time.
To Next Page
Loading...
