Canon LASER CLASS 710 - Page 148

LASER CLASS 730i/720i/710 Chapter 4: Maintenance and Service
4-65
[No.028]
Use it to set the length of time during which the Menu Select screen is indicated on the
LCD.
[No.056 to 061]
Use it to confirm the count type indicated on the Counter Check screen, which appears in
response to a press on the Counter button.
When “0” is selected, count type will not be indicated.
No.056 : fix to total 1 (101) for the counter 1 reading.
No.057 : use it to select a count type for the counter 2 reading.
No.058 : use it to select a count type for the counter 3 reading.
No.059 : use it to select a count type for the counter 4 reading.
No.060 : use it to select a count type for the counter 5 reading.
No.061 : use it to select a count type for the counter 6 reading.
If above selections have been made, the counters will be displayed in order of counter
numbers.
<Soft counter specifications>
The soft counters are classified as follows according to input numbers:
100s : total
200s : copy
300s : print
500s : scan
700s : received print
800s : report print
Guide to the table
Yes : available for the machine
large size (B4 or larger)
small size (smaller than B4)
total 1 (all sizes as 1)
total 2 (large sizes as 1)
1 or 2 under “Counter” : count increments for large-size paper
To make a change so that B4 and larger papers will be counted as large-size, use service
mode: make the following selections, and change bit 0 to “1”: #1 SSSW>SW33.
manuals4you.commanuals4you.com