2-12
Step 3 Perform Initial Setting of the Camera
This completes the initial setting.
Note
To obtain an IP address from the DHCP server, first you need to set an address using VB
Initial Setting Tool, which enables to communicate with the PC for setting. Then, change the
[IP Address Setting] for LAN to [Auto (DHCP)] in [Network] in the Setting page. See "LAN"
( Operation Guide).
The camera will stop issuing IP address assignment requests in 20 minutes after its power
is turned on, upon which detection by VB Initial Setting Tool will be disabled. In this case,
turn on the camera again.
To Next Page
Loading...
