3
35
English
Language [LAN]
With this option you can change the On-Screen display (OSD) language from German to English and backwards.
To change the (menu)language please do as follows:
1
To enter the menu, press the "M" button on your remote control.
2
Use the " " or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item Language [LAN] and confirm with the "OK" button.
4
Select the wanted language English or German using the "+" or "-" key.
5
Then press "OK" again to leave the menu.
Playmode [PLM]
In this menu you can activate additional playmodes that can then be used and selected in addition to the 3 standard playmodes Stereo, Movie
and Music with the Play Mode button. These playmodes are:
• Discrete [DCT]: Surround sound for movies, music, etc. without a virtualizer.
• Night [NGT]: (Virtual) surround sound with reduced dynamic and higher voice clearity at low volume levels for "night usage".
• Party [PTY]: Plays the front channels (L+R) additionally on the surround speakers.
To activate or deactivate an additional playmode please do as follows:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item Playmode [PLM] and confirm by pressing "OK".
4
Select the desired playmode by using the " " or " " button and press "OK".
5
Activate (ON / [ON]) resp. deactivate (OFF / [OFF]) the selected playmode with the "+" or "–" button and exit this playmode by
pressing "OK".
6
To activate or deactivate a different playmode please repeat the steps 4 and 5.
7
Press the "M" button to exit this menu item.
Note: The playmodes Discrete and Party are only selectable if Smart (wireless-)speaker are connected to the Sounddeck 100.
You can find additional information in the description in the "Sub Out" and "Wireless Pairing" part.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
