27
rel. 2.7 - 16.11.2018
ENG
"Passive probes" +030220658 -
9. PT1000 IMMERSION PROBE TECHNICAL SPECIFICATIONS
9.1 Models TST1300000
Immersion probes feature the sensor directly in contact with the liquid, and are installed on the tubing. Wired using the electrical connector.
Storage conditions -40T120 °C
Operating range -40T120 °C
Sensor Pt1000 Class B
Construction Direct immersion with connection to the 1/8” GAS male process fitting as per UNI 338
Electrical connection 4-pin co-moulded nylon, M12x1 (DIN-VDE0627) metric thread, IP67 max. temp. 90°C
Thermal constant over time ca. / approx. 5 s in water - 30 s in air
Sensitive element housing AISI 316
Insulation 100 Mohm a 500 Vcc
Maximum operating pressure 40 bar
Tab. 9.a
Key:
1 sensitive element NTC 10 Kohm
2 stainless steel socket
3 EX14
4 co-moulded body
5 M12 male connector
55.5
1/8” GAS
13
Ø 3
1
2
3
4
5
Fig. 9.a
Accessories:
•
4-pin M12 connector for 1/8
GAS sensor - cable length 3 m
Code TSOPZCW030
150
L=*
Fig. 9.b
Wiring:
1
2
3
PT1000
1red
2red
3 white
• 4-pin M12 connector for 1/8 GAS
sensor
Code TSOPZCM000
• M12 connector can be assembled
on site, recommended cable 3x0.2
mm
2
with outer sheath.
Fig. 9.c
Wiring:
Note: the three-wire connection for the Pt100 must be used
when the controller is fitted accordingly. If not, the ends are to be
connected together on the same terminal.
1
2
4
3
NTC10K
• Welding fitting Code TSOPZP T000
A
Compact thermistor with 1/8”
GAS cyl. fitting
B
1/4” GAS cyl. process fitting
with immersion L= 10.5 mm
25.5
Ø 4
Ø 4.8
EX 17
1/4” GAS CIL.
1/8” GAS CIL.
10.5
A
B
TSN1300000
-40T120
sett/anno
Fig. 9.d
• Welding fitting Code TSOPZRT000
13,5
17
18
3,5
Fig. 9.e
PT1000
Sensor
connector
side view
To Next Page
Loading...
