Maintenance and Troubleshooting
AA2204_en | 2012-07-27 3–17
177 21177 Film Cartridge Failed
to Close
Open the film supply. Manually close the film
cartridge, using the manual rollback knob, to
prevent the film from fogging.
If the error persists, call for service.
178 21178 Rollback Failed to
Leave Home
If the Pause symbol is on, press it to cover the
film cartridge. When the Pause symbol stops
flashing, remove the film cartridge from the
imager. Then reinsert the film cartridge into the
imager.
If the error persists, call for service.
624 21624 Film Supply: Film
Calibration Failure
Calibrate again.
If the error still displays, install a new film
cartridge.
If the error still displays, restart the imager.
If the error persists, call for service.
631 21631 Film Supply: Film
Calibration Failure -
Dmin Outside
Tar g et
The minimum density of the film is too high.
Calibration results for this film are outside the
normal range. Printing will continue with these
parameters.
If the prints are not optimal, do the calibration
procedure again or install another film cartridge.
632 21632 Film Supply: Film
Calibration Failure -
Dmax Outside
Tar g et
The maximum density of the film is lower than
the target density. Calibration results for this film
are outside the normal range. Printing will
continue with these parameters.
If the prints are not optimal, do the calibration
procedure again or install another film cartridge.
922 25922 RF Tag: Internal
Diagnostic Failure
Restart the imager.
If the error persists, call for service.
323 26323 Film Jam in Area 2 Clear the jam.
324 26324 Film Jam in Area 2 Clear the jam.
325 26325 Film Jam in Area 2 Clear the jam.
326 26326 Film Jam in Area 2
or 3
Clear the jam.
543 26543 Film Jam in Area 3 Clear the jam.
544 26544 Film Jam in Area 3 Clear the jam.
Display
Screen
Web
Portal
Web Portal
Message Action
To Next Page
Loading...