Maintenance and Troubleshooting
AA2204_en | 2012-07-27 3–23
Clear Film Jam Code 116 / Jam in Area 1
This error displays as code 21116 at the Web Portal.
1. If the Pause symbol is on, press it and wait until it goes off.
2. Open the film supply and remove the film cartridge from the imager.
3. Look in Area 1 (the upper or lower film supply) and remove any film.
4. Reinsert the film cartridge in the imager.
Related topics
Film Jam Indication and Areas
Clear Film Jam Code 323 / Jam in Area 2
This error displays as code 26323 at the Web Portal.
1. If the Pause symbol is on, press it and wait until it goes off.
2. Open the film supply.
3. Check that the film cartridge is closed. If it is not closed, carefully close the cartridge
cover.
4. Remove any loose film near, in, or partially in the film cartridge.
5. Close the film supply.
Related topics
Film Jam Indication and Areas
To Next Page
Loading...