78
APPENDIX A: SystemVut Controller Display
Service Main Menu Layout (cont)
DISPLAY TEXT EXPA NDED DISPLAY TEXT VALUES UNITS WRITE STATUS POINT
HARDWARE (cont) Hardware Information Menu
AI06 FUNCTION Assigned AI06 Function 0=None,
1=IAQ,
2=OARH,
3=RARH,
4=OAQ,
5=SPRH,
6=OACFM
MBBAI06F
AI07 FUNCTION Assigned AI07 Function MBBAI07F
AI08 FUNCTION Assigned AI08 Function MBBAI08F
DI02 FUNCTION Assigned DI02 Function 0=None,
1=COFS,
2=REMOCC,
3=REMOFF,
4=FILTER,
5=ENTHALPY,
6=GEN STAT,
7=HUMIDISTAT,
8=IAQOVRD,
9=FANSTATUS,
10=PHASEMON
MBBDI02F
MBB Y3 FUNCTION Assigned MBB Y3 Function MBBDI09F
DI12 FUNCTION Assigned DI12 Function MBBDI12F
DI13 FUNCTION Assigned DI13 Function MBBDI13F
DI14 FUNCTION Assigned DI14 Function MBBDI14F
RELAY 06 FUNCTION Assigned Rly 06 Function 0=No ne,
1=ALM Relay,
2=PE1
,3=PE2
MBBRY06F
RELAY 11 FUNCTION Assigned Rly 11 Function MBBRY11F
MBB PART # MBB Part Number CEPL131117--- xx--- R BD_CEPL
MBB PP # MBB Program Part Number CEPP130644--- xx--- xx--- xx--- R BD_CEPP
MBB SERIAL # Base Board serial number xxxxMxxxxx BD_SER
CALIBRATION Calibration Menu
OATTRIMOFFSET OAT Sensor Trim Offset --- 10 to 10 °F Configurable OAT_TRIM
RAT TRIM OFFSET RAT Sensor Trim Offset --- 30 to 30 °F Configurable RAT_TRIM
FST TRIM OFFSET FST Sensor Trim Offset --- 10 to 10 °F Configurable FST_TRIM
SPTTRIMOFFSET SPT Sensor Trim Offset --- 30 to 30 °F Configurable SPT_TRIM
SLIDER SEN. TRIM SPTO Sensor Offset Trim --- 1 t o 1 °F Configurable SPTOTRIM
SPRH TRIM OFFSET SPRH Sensor Trim Offset --- 15 to 15 % Configurable SPRHTRIM
IAQ TRIM OFFSET IAQ sensor trim offset --- 200 to 200 PPM Configurable IAQ_ TRIM
OAQ TRIM OFFSET OAQ Sensor Trim Offset --- 200 to 200 PPM Configurable OAQ_TRIM
OARH TRIM OFFSET OARH Sensor Trim Offset --- 15 to 15 % Configurable OARHTRIM
RARH TRIM OFFSET RARH Sensor Trim Offset --- 15 to 15 % Configurable RARHTRIM
CIR.A SSP TRIM Cir.A SSP Sensor T rim --- 50 to 50 PSI Configurable SSPATRIM
CIR.A SDP TRIM Cir.A SDP Sensor Trim --- 50 t o 50 PSI Configurable SDPATRIM
ECO FEEDBACK TRIM Econ Fdback Trim Offset --- 15 t o 15 % Configurable EC1DTRIM
OACFMTRIMOFFSET OACFM sensor trim offset --- 200 to 200 CFM Configurable OCFMTRIM
COMMISSION REPORTS Commission Report Menu
SYSTEM STARTUP CHECKLIST SYSTEM STARTUP CHECKLIST MENU
QUICK SET CHKLIST QUICK SETUP CHECKLIST 0=Undone,
1=Perform,
2=Done
Configurable CHK_QUIK
NETWORK CHKLIST NETWORK SETUP CHECKLIST 0=Undone,
1=Perform,
2=Done
Configurable CHK_NET
SYSTEM AUTOTEST Checklist Auto Test 0=Undone,
1=Perform,
2=Done
Configurable CHK_A TS T
ADVANCED SERVICE Advanced Service Restricted Access Menu
RESTORE DEFAULTS? KEEPCONFIG SCREEN POP--- UP Yes/No Command RESFDFLT
EDIT MODEL NUMBER Edit Equipment Model Number
EDIT SER NUMBER Edit Equip Ser Num Menu
CLEAR COMPONENT DATA RESET COMPONENT DATA MENU
2POS/ERV DATA Reset 2Position/ERV Data Ye s/No Command CR_ERV2P
COMP A1 DA TA Reset Compressor A1 Data Yes/No Command CR_A1
ALARM RELAY DATA Reset Alarm Relay Data Yes/No Command CR_ALM
CCH RELAY DATA Reset CCH1 Relay Data Yes/No Command CR_CCHR1
ECON DAMPER DA TA Reset Econ Damper Data Ye s/No Command CR_DAMP
FULL LOAD DATA Reset Full Load Data Yes/No Command CR_FLOAD
FREE COOL DATA Reset Free Cooling Data Ye s/No Command CR_FREEC
HEAT 1 DATA ResetHeatStage1Data Yes/No Command CR_HTR_1
To Next Page
Loading...
