Carrier Zone Ctrl II - To Set up the Driver; Driver

To set up the driver
Zone Ctrl II and
VAV Zone II Secondary Duct Installation and Start-up Guide CARRIER CORPORATION ©2019
Error! No text of specified style in document.
35 All rights reserved
After discovering your Zone Ctrl II, you may want to change the driver's properties in the i-Vu® interface to suit
your application.
1 On the i-Vu® navigation tree, right-click the Zone Ctrl II.
2 Select
Driver Properties
and make changes if needed.
Driver
On the
Driver
>
Update
tab, you can get a Module Status and add, update, or delete the driver and the
touchscreen file.
1 To update the driver, do one of the following:
If the driver is...
In the
Driver Version
drop-down list Select the driver and click
Apply
or
Accept
..
Not in the
Control Program
drop-
down list
a. Click
Add
.
b. Browse to select the driver.
c. Click
Open
.
d. Click
Continue
.
e. Click
Apply
or
Accept
.
2 To change, delete, or upload a screen file, click
Add
under
Screen File
and browse to your touchscreen file or
select from the drop-down list..
3 Click
Continue
. When message appears
File added successfully
, click
Close
.
4 Click
Close
again.
5 Click the
Download
button.
To set up the driver