Carrier Zone Ctrl II - Specific Events; Switches, Jumpers, Options; Flow Calibration Archive

To set up the driver
Zone Ctrl II and
VAV Zone II Secondary Duct Installation and Start-up Guide CARRIER CORPORATION ©2019
Error! No text of specified style in document.
40 All rights reserved
Specific Events
On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the following BACnet
alarms:
Specific alarms:
• Flow Control Alarm
• Reheat Valve Alarm (future use)
NOTES
• To set up alarm actions for controller generated alarms, see See Alarms in i-Vu® Help.
• Reheat Valve Alarms are for future use.
Module Generated Alarm
Description
Short message shown on the i-Vu®
Alarms
page or in an alarm action when this
type of alarm is generated.
Events
Alarm Category and Alarm
Template
See Alarms in i-Vu® Help.
Enable
Clear these checkboxes to disable Alarm or Return to normal messages of this
type from this controller.
Notification Class
Do not change this field.
Switches, Jumpers, Options
The
Switches, Jumpers, Options
page shows the current physical settings on the Zone Ctrl II.
Flow Calibration Archive
The
Flow Calibration Archive
page shows measured flow and sensor readings that were entered in the i-Vu®
interface Test and Balance or through the stand-alone Airflow Test and Balance Utility. Editing Airflow microblock
properties outside of Test and Balance will not change the values on this page.