SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
9
8. Check machine
(a)To avoid personal injury, every day before starting the machine,
check the machine carefully.
(b) In the tour check carefully around the machine, be sure to “check
before the start of the inspection” described in the chapter all.
9. Use handrails and ladders
Always observe this precaution to ensure safety!
(a) The drop is one of the main causes for personal injury
(b) Up-and-down the machine, always with the pedal and handrails to
maintain three points of contact, and machine-oriented.
(c) Do not put any lever, the cabin door handle as a handrail.
(d) Can not jump on/off the machine, and do not get on/off the moving
machine.
(e) When using the machine, pay attention to the platform and handrails
slippery.
(f) Oil, mud and water in handrails and shoes should be cleaned any
time.
10. Adjust the position of the seat
(a) Uncomfortable seat is likely to cause fatigue, leading to operational
mistake.
(b) In each exchange machine operator, and should be re-adjust the
position of the seat.
(c) When the operator back on seat back, you should be able to step on
the pedal to the end, and correct the operation of the joystick. If not,
move forward and backward seat, re-adjust.
11. Fasten seat belts
(a) In the case of a rollover accident, the operator may be injured or
throwing out of the cabin, or may be pressing down by the machine,
then cause serious injury or death.
(b) Before operating the machine, check the seat belts, buckles and
solid set pieces carefully. If you find any damage of the seat belts, it
should be replaced before operating.
(c)While operating the machine, be sure to sit on the operating chair
and fasten your seat belts, in order to minimize the possibilities of
accident injuries
(d) Best to replace seat belt per three years, no matter what condition it
is.
To Next Page
Loading...