SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
2
BEFORE SERVICING THIS MACHINE
It is the responsibility of the owner and all service and maintenance personnel to avoid accidents
and serious injury by keeping this machine properly maintained.
It also is the responsibility of the owner and all service and maintenance personnel to avoid
accidents and serious injury while servicing the machine.
No one should service or attempt to repair this machine without proper training and supervision.
All service and maintenance personnel should be thoroughly familiar with the procedures and
precautions contained in this manual.
All personnel also must be aware of any federal, state, provincial or local laws or regulations
covering the use and service of construction equipment.
The procedures in this manual do not supersede any requirements imposed by federal,
state,provincial or local laws.
CARTER can not anticipate every possible circumstance or environment in which this machine
may be used and serviced.
All personnel must remain alert to potential hazards.
Work within your level of training and skill.
Ask your supervisor if you are uncertain about a particular task. Do not try to do too much too fast.
Use your common sense.
Noise and vibration Declaration
Noise：
Normal working:
LwA=93dB(A), uncertainty =1.5dB(A)
Measured according to ISO 6395:2008;
LpA=84dB (A), uncertainty =1.5dB (A);
Measured inside the cab according to ISO 6396:2008;
Vibration:
The vibration total value to which the hand-arm system is subjected does not exceed 2.5m/s
2
;the
height root mean square value of weighted acceleration to which the whole body subjected is
6.6m/s
2
.
Note: vibration levels are influenced by many different parameters. Many items are listed below:
-Operator training, behavior, mode and stress;
-Job site organization, preparation, environment, weather, and material;
-Machine type, quality of the seat, quality of the suspension system, attachments, and condition
of the equipment.
To Next Page
Loading...