Carter CT12 - Preparation for Disassembly

SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
61
3. Disassembly and assembly
 Do not wear gloves when using hammers.
 Use rods of the specified soft material for removing pins. Do not use a hammer as a pad.
 Do not place fingers in holes when centering.
 Heavy parts must be adequately supported before removing bolts.
4. Cranes
 In principle, use a crane for objects heavier than 44lb (20kg).
 Crane operation and hoisting must be per- formed only by qualified personal.
 Pay careful attention to the center of gravity when hoisting, and do not stand under the lifted objects.
5. Others
 To work under a jacked-up carrier, be sure to place wood pieces under it.
 When charging batteris, make sure there are no open flames in the immediate vicinity.
 All electric tools must be grounded.
 Before welding the machine, remove the battery.
 When removing the battery, be sure to dis- connect negative (-) cord first.
 When mounting the battery, be sure tp connect the positive (+) cord first.
5.1.3 Preparation for disassembly
1. Cleaning
Remove mud and dirt from the body before disassembly.
2. Acceptance inspection
The machine must be checked before it is disassembled to record existing conditions, such as those
listed below.
Model, serial number, and hourmeter reading
 Reason for repair and repair history
 Element stains
 Fuel and oil condition
 Parts damage *(Take photographs if nessesary.)
3. Equipment and tools
prepare equipment, tools, cranes and parts storage racks as required.
 Precautions for disassembly and reassembly
4. Disassembly
 Follow the specified disassembly procedures.
 Make alignment marks to insure correct reassembly.
 Arrange disassembled parts in an orderly way, and attach identification tagsorputmarksifneeded.