SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
90
7.4 Loading machinery
The following rules shall be followed for loading:
The orientation of the machine is as follows:
With working device: put the working device at the front and
walk forward.
Without working device: walk backwards as shown in the
figure (trailer with ladder must be used).
The center line of the machine shall correspond to the center
line of the trailer.
Slowly drive the machine onto the slope.
1) Remove the anti rollover support: remove the anti rollover
device from the whole machine and pack it well to avoid
scratches on the paint surface. Put it into the container after
the whole machine is loaded into the container.
2) Hoisting: according to the height of the container, a special
bracket is made and placed on the upper and lower layers,
which can not only save space, increase the utilization rate of
container space, but also save transportation costs.
3) Loading container: when the transportation forklift
machine holds up the support and starts to tilt towards the
container, walk forward slowly until the bracket firmly
contacts the container.
CAUTION
To prevent damage to the bucket cylinder during
transportation, the bucket one end of the oil cylinder
shall be padded with wood blocks to prevent it from
touching the bottom plate.
Stop the engine and remove the key from the switch.
Operate the control lever several times until the pressure
in the hydraulic cylinder is completely released.
Turn the safety lever to the vertical direction to prevent
the safety accident caused by misoperation.
To Next Page
Loading...