SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
91
7.5 Transport
(a) Place spacer blocks at the front and rear of the track. To prevent the machine from moving during transportation. The machine
shall be tied firmly with iron chain or steel wire rope of appropriate strength.
(b) Pay special attention to fixing the machine firmly so that it will not slide to one side.
CAUTION
● Horizontal servo mechanism, outriggers and other
movable devices that may cause danger during
transportation or driving shall be reliably locked at
their transportation position.
● Tie the chain or rope to the frame of the machine,
and do not cross or press the chain or cable on the
hydraulic pipeline or hose.
In the transportation should enable hinged locking mechanism in figure 1:
Non transport should enable hinged locking mechanism in Figure 2
Figure 1 Figure 2
7.6 Unloading
The following rules should be observed during loading:
The direction of the machine is as follows:
The center line of the forklift shall correspond to the center line of the container.
Slowly use the forklift machine to hold the support and drive it to the flat ground.
1) Take out the anti rollover support: take out the anti rollover device from the container and place it properly to ensure that the
package is intact to avoid scratching the paint surface.
To Next Page
Loading...