SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
92
2) Unloading bracket: when the transportation forklift lifts the bracket and starts to tilt towards the container, walk forward slowly
until the bracket firmly contacts the ground,
3) Remove the bracket: when the bracket is placed firmly on the ground, slowly raise the machine according to the position of the
hanging shop to completely separate it from the bracket, and slowly move forward until the machine firmly contacts the ground,
4) Install the roll over frame assembly: after the machine is stable, install the roll over frame on the machine。
The rear end of the trailer flat plate meets the slope in a
protruding shape, so drive carefully.
Prevent possible damage to the working device. When
unloading, always keep the included angle between the
stick and the boom at 90 °.
Prevent possible damage to the hydraulic cylinder. Do
not let the bucket of the machine collide violently with
the ground.
To Next Page
Loading...